Pit & Quarry - April 2009

Belt failure equates to lost money and production time. Any investment in conveyor belting should also be an investment in reduced overall costs and revenue improvement throughout the life of the belt. When Vulcan Materials Co., Calera, Ala., purchased a 4-1000 belt seven years ago, they expected to get the most from their investment. After three years of continuous problems, the operation turned to distributor Dyson Conveyor Maintenance of Hueytown,

Fenner Dunlop’s UsFlex conveyor belting carries limestone out of the pit at Vulcan Materials Co., Calera, Ala.

PEDESTAL BOOM REBUILDING

HAMMER REMANUFACTURING

CYLINDER

-Worn out or pitted?

We can build it up and rebore it to the specifications or if need be replace the cylinder entirely.

PISTON

-Cracked or Scouring?

Can be rebuilt or replaced.

THRUS T or IMPACT RING

-Egg shaped or cracked?

Can be built up and rebored to specs or replaced.

Every hammer we repair is cycle tested for proper operation before it leaves our doors.

CRACKED HEADS DUE TO DRY FIRING, PR YING OR IMPROPER USE?

NOT A PROBLEM!!!

At Hydraulic Breaker Service we specialize in refurbishing cracked front heads, whether just small hair line cracks or completely cracked in two.

We also stock a wide range of used and rebuilt tool holders and front heads.

At Hydraulic Breaker service we specialize in servicing breakers that your local dealers might say are beyond repair due to excessive wear, cracks, or cost.

Ho w many times have you sent out a hammer only to find out its repair cost exceeds 50% or higher than that of a new hammer?

This is where Hydraulic Breaker Service enters the picture. With our high quality precision work we can save you the exorbitant cost that other shops and dealers charge. l Remanufactured hammers with warranties l Wide range of USED & NE W parts for all makes of hammers